|
Post by tanney on Oct 3, 2010 8:03:23 GMT -7
Hi again everyone,
Does anyone know how to change the lugs on the rear wheels, have to make them longer for the new wheels, does it require pulling the axle's? The front ones were easy because they were attached to the drum..
tx
Nick
|
|
|
Post by markeb01 on Oct 3, 2010 16:55:28 GMT -7
I changed a couple of mine without removing the axles many years ago using a tie rod puller similar to the one shown. Perhaps someone you know has one you can borrow. www.thetoolwarehouse.net/p-4469-otc-7315a.aspxFor installing the new ones I just set them in place on the back and pulled them in with lugs nuts. I placed a couple of well greased washers over the stud, installed the lug nut backwards (with the flat against the washers) then pulled them in place with an impact wrench. This may or may not work depending on the length of the new studs.
|
|